Linkaggregation Icmpwatch Address - Fujitsu XG0224 User Manual

XG Series User's Guide

5.1.1.24 linkaggregation icmpwatch address

Function
Available Model
Syntax
Options
Use Mode
Explanation
Caution
Default
Set the destination address for "ether" L3 monitoring of link aggregation.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
linkaggregation <group> icmpwatch address <dst_addr>
<group>
• Link aggregation group number
Set a link aggregation group number with a decimal number.
Range
1 to 13 XG0224
1 to 26 XG0448
1 to 22 XG0440DC / XG0440DCR
1 to 10 XG2600
<dst_addr>
• Destination IP address to be monitored
Specify the destination IP address to be monitored.
The allowable range is as follows:
1.0.0.1 to 126.255.255.254
128.0.0.1 to 191.255.255.254
192.0.0.1 to 223.255.255.254
Configuration mode (admin class)
Set the operation information for destination monitoring.
This command sends an ICMP ECHO packet from the specified link aggregation group to
the destination IP address, specified by <dst_addr>, and checks the presence of the
destination by receiving a response.
Do not set the IP address of the local device in <dst_addr>. Also, make sure that the
specified IP address is included in the same subnet.
If any of the above three addresses is specified, the Ethernet L3 monitoring function will
not operate normally.
It is assumed that the Ethernet L3 monitoring function is not used for the link aggregation.
115
Chapter 5 Command Reference
Model
Port Information Settings