Filter Management Tasks; Renumbering Filter Policy Entries; Filter Policies - Alcatel-Lucent 7210 SAS M Configuration Manual

Filter Management Tasks

This section discusses the following filter policy management tasks:
•
•
•
•

Renumbering Filter Policy Entries

The system exits the matching process when the first match is found and then executes the actions
in accordance with the specified action. Because the ordering of entries is important, the
numbering sequence can be rearranged. Entries should be numbered from the most explicit to the
least explicit.
Use the following CLI syntax to renumber existing MAC or IP filter entries to re-sequence filter
entries:
CLI Syntax: config>filter
Example
7210 SAS M, X Router Configuration Guide
Renumbering Filter Policy Entries on page 113
Modifying an IP Filter Policy on page 115
Detaching/Deleting a Filter Policy on page 118
Copying Filter Policies on page 120
ip-filter filter-id
renum old-entry-number new-entry-number
mac-filter filter-id
renum old-entry-number new-entry-number
:
config>filter>ip-filter# renum 10 15
config>filter>ip-filter# renum 20 10
config>filter>ip-filter# renum 40 1

Filter Policies

Page 113