Alcatel-Lucent 7210 SAS M Configuration Manual page 68

Show Commands
session
Syntax session [src ip-address [dst ip-address] | detail]
Context show>router>bfd
Description This command displays session information.
Parameters ip-address — Only displays the interface information associated with the specified IP address.
Output BFD Session Output — The following table describes the show BFD session output fields:
State
Protocol
Tx Intvl
Tx Pkts
Rx Intvl
Rx Pkts
Mult
Sample Output
*A:7210-SAS>show>router>bfd# session
===============================================================================
BFD Session
===============================================================================
Interface
Remote Address
-------------------------------------------------------------------------------
F_Port
F_Lag
C_Lag
-------------------------------------------------------------------------------
No. of BFD sessions: 3
===============================================================================
*A:7210-SAS>show>router>bfd#
Page 68
Values ipv4-address
Label
Displays the administrative state for this BFD session.
Displays the active protocol.
Displays the interval, in milliseconds, between the transmitted BFD mes-
sages to maintain the session
Displays the number of transmitted BFD packets.
Displays the expected interval, in milliseconds, between the received BFD
messages to maintain the session
Displays the number of received packets.
Displays the integer used by BFD to declare when the neighbor is down.
22.1.1.1
23.1.1.1
25.1.1.2
a.b.c.d (host bits must be 0)
Description
State
Protocol
Up (3)
ospf2
Up (3)
ospf2
Up (3)
ospf2
7210 SAS M, X Router Configuration Guide
Tx Intvl Rx Intvl Mult
Tx Pkts Rx Pkts
100 100 3
801259 801275
300 300 3
267087 267093
300 300 3
267005 266996