Alcatel-Lucent 7210 SAS M Configuration Manual page 70

Show Commands
interface
Syntax interface [{[ip-address | ip-int-name] [detail]}
Context show>router
Description
This command displays the router IP interface table sorted by interface index.
Parameters
ip-address — Only displays the interface information associated with the specified IP address.
ip-int-name — Only displays the interface information associated with the specified IP interface name.
detail — Displays detailed IP interface information.
Output Standard IP Interface Output — The following table describes the standard output fields for an IP
interface.
Interface-Name
Type
IP-Address
Adm
Opr
Mode
Port
Sample Output
A:ALU-7210# show router interface
===============================================================================
Interface Table (Router: Base)
===============================================================================
Interface-Name
-------------------------------------------------------------------------------
system
-------------------------------------------------------------------------------
Page 70
Values
ipv4-address
Label
The IP interface name.
n/a — No IP address has been assigned to the IP interface, so the IP
address type is not applicable.
Pri — The IP address for the IP interface is the Primary address on
the IP interface.
The IP address and subnet mask length of the IP interface.
n/a
Down — The IP interface is administratively disabled.
Up — The IP interface is administratively enabled.
Down — The IP interface is operationally disabled.
Up — The IP interface is operationally disabled.
Network — The IP interface is a network/core IP interface.
The physical network port associated with the IP interface.
IP-Address
72.22.24.169/32
a.b.c.d (host bits must be 0)
Description
— Indicates no IP address has been assigned to the IP interface.
Adm Opr
Up Up
7210 SAS M, X Router Configuration Guide
Mode Port/SapId
PfxState
Network system
n/a