Alcatel-Lucent 7210 SAS M Configuration Manual page 79

*A:7210-SAS>show>router# status
===============================================================================
Router Status (Router: Base)
===============================================================================
-------------------------------------------------------------------------------
Router
OSPFv2-0
ISIS
MPLS
RSVP
LDP
BGP
OSPFv3
Max IPv4 Routes
Max IPv6 Routes
Total IPv4 Routes
Total IPv6 Routes
ECMP Max Routes
Mcast Info Policy
Triggered Policies
===============================================================================
*A:7210-SAS>show>router#
tunnel-table
Syntax tunnel-table [ip-address[/mask]] [protocol protocol | sdp sdp-id] [summary]
Context show>router
Description
This command displays tunnel table information. Note that auto-bind GRE tunnels are not displayed in
show command output. GRE tunnels are not the same as SDP tunnels that use the GRE encapsulation
type.
Parameters ip-address[/mask] — Displays the specified tunnel table's destination IP address and mask.
protocol protocol — Dislays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Output Tunnel Table Output — The following table describes tunnel table output fields.
Destination
Owner
Encap
7210 SAS M, X Router Configuration Guide
Admin State
Up
Up
Not configured
Up
Up
Not configured
Up
Not configured
16000
No Limit
3
0
1
default
No
Label
The route's destination address and mask.
Specifies the tunnel owner.
Specifies the tunnel's encapsulation type.
IP Router Configuration
Oper State
Up
Up
Not configured
Up
Up
Not configured
Up
Not configured
Description
Page 79