Alcatel-Lucent 7210 SAS M Configuration Manual page 146
Hide thumbs
Also See for 7210 SAS M:
- Service manual (952 pages) ,
- Configuration manual (558 pages) ,
- Quality of service manual (404 pages)
Table of Contents
Advertisement
Show Commands
associations — Appends information as to where the filter policy ID is applied to the detailed filter
counters — Displays counter information for the specified filter ID. Note that egress counters count
type entry-type — Displays information on the specified filter ID for the specified entry-type only
Output
Show Filter (no filter-id specified) — The following table describes the command output for
the command when no filter ID is specified.
Sample Output
A:ALA-49# show filter ip
===============================================================================
IP Filters
===============================================================================
Filter-Id Scope
-------------------------------------------------------------------------------
1
3
6
10
11
-------------------------------------------------------------------------------
Num IP filters: 5
===============================================================================
A:ALA-49#
*A:Dut-C>config>filter# show filter ip
===============================================================================
IP Filters
===============================================================================
Filter-Id
-------------------------------------------------------------------------------
10001
fSpec-1
-------------------------------------------------------------------------------
Num IP filters: 2
===============================================================================
Page 146
policy ID output.
the packets without Layer 2 encapsulation. Ingress counters count the packets with Layer 2
encapsulation.
Label
Filter Id
Scope
Applied
Description
Applied Description
Template Yes
Template Yes
Template Yes
Template No
Template No
Scope
Applied Description
Template Yes
Template Yes
The IP filter ID
The filter policy is of type template.
Template —
The filter policy is of type exclusive.
Exclusive —
The filter policy ID has not been applied.
No —
The filter policy ID is applied.
Yes —
The IP filter policy description.
BGP FlowSpec filter for the Base router
7210 SAS M, X Router Configuration Guide
Description
Total:
2
Advertisement
Table of Contents
