Alcatel-Lucent 7210 SAS M Configuration Manual page 138

Configuration Commands
tcp-ack
Syntax tcp-ack {true | false}
no tcp-ack
Context config>filter>ip-filter>entry>match
Description This command configures matching on the ACK bit being set or reset in the control bits of the TCP
header of an IP packet as an IP filter match criterion. Note that an entry containing L4 match criteria
will not match non-initial (2nd, 3rd, etc) fragments of a fragmented packet since only the first
fragment contains the L4 information.
The no form of the command removes the criterion from the match entry.
Default
no tcp-ack
Parameters true — Specifies matching on IP packets that have the ACK bit set in the control bits of the TCP
false — Specifies matching on IP packets that do not have the ACK bit set in the control bits of the
tcp-syn
Syntax tcp-syn {true | false}
no tcp-syn
Context config>filter>ip-filter>entry>match
Description This command configures matching on the SYN bit being set or reset in the control bits of the TCP
header of an IP packet as an IP filter match criterion. Note that an entry containing L4 match criteria
will not match non-initial (2nd, 3rd, etc) fragments of a fragmented packet since only the first
fragment contains the L4 information.
The SYN bit is normally set when the source of the packet wants to initiate a TCP session with the
specified destination IP address.
The no form of the command removes the criterion from the match entry.
Default no tcp-syn
Parameters true — Specifies matching on IP packets that have the SYN bit set in the control bits of the TCP
false — Specifies matching on IP packets that do not have the SYN bit set in the control bits of the
Page 138
header of an IP packet.
TCP header of the IP packet.
header.
TCP header.
7210 SAS M, X Router Configuration Guide