KTM 690 ENDURO EU Owner's Manual page 74

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Lean the motorcycle on the side stand.
–
Shift gear to neutral.
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning the adjusting screws
Specification
Chain tension
Turn the adjusting screws
chain adjusters
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should repeat this measurement at differ-
ent chain positions.
–
Tighten nuts
–
Make sure that the chain adjusters
–
Tighten nut
100250-10
Specification
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm) enables different
secondary transmissions with the same chain length.
The chain adjusters
.

.

left and right so that the markings on the left and right

are in the same position relative to the reference marks

.

are fitted correctly on the adjusting screws

.

can be turned by 180°.

left and right.

5 mm (0.2 in)
M25x1.5 90 Nm (66.4 lbf ft)
72
. The

.
