Combination Instrument - Odo Display; Combination Instrument - Setting/Resetting Trip 1 Display - KTM 690 ENDURO EU Owner's Manual

OPERATING ELEMENTS
Combination instrument - ODO display
5.22
Combination instrument - setting/resetting TRIP 1 display
5.23
Info
The tripmaster TRIP 1 operates constantly and counts up to 999.9.
You can use the tripmaster to measure trips or the distance between refuelling stops. After reaching 999.9, the tripmaster begins
again at 0.0.
–
Switch on the ignition by turning the ignition key in the position .
–
Press the MODE button several times until the ODO display mode is active.
–
Keep the MODE button and the SET button pressed simultaneously.
The time begins to flash.
–
Press the MODE button to adjust the hour.
–
Press the SET button to adjust the minute.
–
Keep the MODE button and the SET button pressed simultaneously.
The time is set.
700115-10
In ODO mode, the total distance covered is shown in kilometers or miles.
Info
This value remains intact even if the battery is disconnected and/or the fuse blows.
700120-01
30