Checking Headlamp Setting - KTM 690 ENDURO EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Checking headlamp setting

9.61
A 0 0 A
–
Press the new flasher bulb carefully into the holder and turn it clockwise as far as it will
go.
Flasher light (BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and turn it first counterclockwise until you feel it click into the thread.
Tighten the screw.
–
Check the flasher function.
–
On a light-colored wall with a horizontal area in front of it, make a mark as high as the
center of the low beam headlight.
–
Make another mark at a distance of
Specification
B 0 0 B
Distance

–
Stand the motorcycle at a distance of
beam.
Specification
400408-10
Distance

–
Check the headlamp setting.
The boundary between light and dark must be exactly on the lower mark for a motor-
cycle with driver.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. (
P. 158)
under the first mark.

5 cm (2 in)
in front of the wall and switch on the low

5 m (16 ft)
P. 119)
118