Adjusting The Handlebar Angle; Handlebar Position - KTM 690 ENDURO EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the handlebar angle
9.16

Handlebar position

9.17
A 0 0 A
B 0 0 B
x
–
Loosen screw
–
Move the handlebar to the desired position and slightly tichten the screws.
–
Move the handlebar carefully in both directions as far as it will go.
» If the handlebar instruments touch the fuel tank:
–
Correct the handlebar angle.
100279-10
–
Fully tighten screw
Specification
Screw, handlebar clamp
On the upper triple clamp, there are 2 holes at a distance
Distance between holes

The holes on the handlebar support are placed at a distance
Distance between holes

The handlebar can be mounted in 4 different positions. In this way, the handlebar can be
installed in the position most comfortable for the rider.
400271-11
.

Info
The distance between the handlebar support and the handlebar clamp
must be the same at the front and rear.
.

M8
15 mm (0.59 in)
3.5 mm (0.138 in)
Loctite ® 243™
20 Nm
(14.8 lbf ft)
to each other.

from the center.

67