Display Screen - Sony XDS-1000 Operation Manual

6 Shuttle/jog/variable-speed playback
control section
1 SHTL/JOG button
2 VAR/JOG button
3 JOG indicator
a SHTL/JOG button
Press this button, turning it on, to perform shuttle or jog
playback with the shuttle/jog dial.
b VAR/JOG button
Press this button, turning it on, to perform variable-speed
or jog playback with the shuttle/jog dial.
c JOG indicator
Lights in green when the shuttle/jog dial is in jog mode.
d Jog/shuttle direction indicators
These show the playback direction in jog, shuttle, or
variable-speed mode.
b (green): Lights during playback in the reverse direction.
B (green): Lights during playback in the forward
direction.

Display screen

Basic operation screen
This unit supports "1-in/1-out mode" and "VTR mode"
operation. Parts of the display screen vary depending on
the operation mode. The following screen shows 1-in/1-
out mode, as an example.
4 Jog/shuttle direction
indicators
5 Shuttle/jog dial
x (red): Lights during still image display.
e Shuttle/jog dial
The dial switches between shuttle/variable-speed mode
and jog mode each time that you press it all the way in.
Shuttle/variable-speed mode: The dial is in the raised
position.
Jog mode: The dial is in the depressed position (the JOG
indicator is lit).
Turn the dial to the right to play in the forward direction,
and turn it to the left to play in the reverse direction.
• In jog mode, the playback speed varies from –1 to +1
times normal speed, according to the rotation speed of
the dial. There are no detents.
• In shuttle mode, the playback speed varies in the range
±20 times normal speed, according to the angular
position of the dial. There is a detent at the center
position, for still image playback.
• In variable-speed mode, you can make fine adjustments
to the playback speed over the range from –2 to +2 times
normal speed, according to the angular position of the
dial. There is a detent at the center position, for still
image playback.
Regardless of the playback mode, you will normally press
the SHTL/JOG or VAR/JOG button before turning the
dial. But it is also possible to put the unit into shuttle, jog,
or variable-speed mode simply by turning the dial (by
setting setup menu item 101 SELECTION FOR SEARCH
DIAL ENABLE to "dial").
Note
If you do set the above item to "dial", then you should
return the shuttle/jog dial to the center position after
conducting shuttle or variable-speed playback. If you do
not return the dial to the center position, playback in
shuttle or variable-speed mode can start because of
vibrations during other operations.
21
Front Panel