Sony XDS-1000 Operation Manual page 108

Item number Item name
926
DVB-ASI SETTING
Sub-item
1 I/O MODE
2
TS MODE
3 ENC RATE(Mbps)
4
RESOLUTION
5 PROGRAM NUMBER
6 OUTPUT MODE
7 PACKET LENGTH
8 META PACKET OUT
9 PID(PMT)
10 PID(PCR)
108
Setup Menu
Menu items in the 900s, relating to digital process
Settings
Sets the parameters for DVB-ASI output, and specifies the number of the
a) b)
program to receive when DVB-ASI signals are input.
Sets DVB-ASI input /output.
input [in]: Fixed input mode
output [out]: Fixed output mode
c) Selects the TS mode. (59.94i/29.97P/50i/25P mode only).
HDV: HDV mode
Manual [manu]: Encoding rate mode
Sets the encoding rate.
15.00Mbps to 25.00 to 43.25Mbps: Sets the encoding rate. You can set
the rate in units of 0.01 Mbps (or units of 0.20 Mbps, when the
SHIFT button is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
c) Selects the number of horizontal pixels for the 1080i format. (59.94i/
29.97P/50i/25P mode only).
1440: 1440
When sub-item TS MODE of menu item 926 is set to "HDV", this is
fixed as "1440".
When the encoding rate is set to lower than 35.00 Mbps with sub-
item ENC RATE(Mbps), this is also fixed as "1440".
1920: 1920
Specifies a DVB-ASI input/output signal program number.
1 to 100 to 65535: Sets the program number (decimal).
You can set this in units of 1 (or 20 when the SHIFT button is held
down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Selects the output mode.
Packet [packt]: Packet mode
Burst: Burst mode
Selects the packet length.
188Byte [188B]: 188 bytes
204Byte [204B]: 204 bytes
Specifies output of DVB-ASI TS signal metadata packets.
on: Output metadata packets.
off: Do not output metadata packets
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Changes the PMT packet PID value for DVB-ASI output.
30 to 81 to 1FFE: Set PID value (as a hexadecimal value).
You can set the value over the range from 30 to 1FFEh in 1 units (or
20 units, when the SHIFT button is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Note
Do not use the same PID value as for any other sub-item.
Changes the PCR packet PID value for DVB-ASI output.
30 to 134 to 1FFE: Set PID value (as a hexadecimal value).
You can set the value over the range from 30 to 1FFEh in 1 units (or
20 units, when the SHIFT button is held down).
- - -: When sub item TS MODE of menu item 926 is set to "HDV".
Note
Do not use the same PID value as for any other sub-item.