Sony XDS-1000 Operation Manual page 125

Alarm message in status
display area
TC EXT!
REGEN mode!
REC mode!
STOP ONCE!
Exit THUMBNAIL mode!
REMOTE!
No Media!
PORT SELECT mismatch.
Select PB Port.
No EM Space
EM Full!
Illegal Operation!
Media is not Ready.
During recording operations
Alarm message in status
display area
Input Sig!
ILL. REC!
MEM. Full!
PORT SELECT mismatch.
Select REC Port.
REC STOP WITHIN 2MIN RECORDING IS TERMINATED WITHIN 2
Description/action
This appears when TCG on page P4 TC of the function menu is set to "EXT", and you try to preset
timecode or user bits by setting PRST/RGN to "PRESET".
Set TCG to "INT" (see page 46).
This appears when PRST/RGN on page P4 TC of the function menu is set to "TC" or "VITC", and
you try to preset timecode or user bits.
Set PRST/RGN to "PRESET" (see page 46).
Stop recording and try again.
This appears when an attempt is made to change media during recording or playback.
Stop the recording or playback and try the operation again.
This appears when an attempt is made to change media while the clip list screen is displayed.
Switch to the basic operation screen or the video monitor screen and try the operation again.
Press the REMOTE button, turning it off, to put this unit into local control mode.
Try again after loading an SxS memory card.
This appears when you have selected an SxS memory card as media and have attempted to
specify the index picture by pressing the INDEX function button (F1) on page P5 OTHER of the
function menu.
This appears when any essence mark was not recorded because there is no space before and
after the desired position.
Delete unneeded shot marks 0 to 9 in the chapter thumbnail screen.
This appears when no more essence marks can be recorded.
Delete unneeded shot marks 0 to 9 in the chapter thumbnail screen.
This appears when an attempt is made to carry out an invalid operation.
The media is in the course of being mounted or has not been loaded.
Alarm message in video monitor screen Description/action
VIDEO INPUT SIGNAL DOES NOT
MATCH SYSTEM SETUP.
ENCODING DOES NOT SYNCHRONIZE
WITH REF VIDEO.
MEMORY FULL !!
–
MINUTES AUTOMATICALLY.
BECAUSE THE CLIP IS REACHED TO
MAXIMUM DURATION.
RECORDING IS TERMINATED WITHIN 2
MINUTES AUTOMATICALLY.
BECAUSE OF INTERNAL LIMITATION.
This appears when the signal that does not
correspond to the system frequency or the number of
lines set in this unit is being input, or when HD-SDI is
selected as a video input signal while setting the SD
signal recording.
Input a signal that matches the system frequency, or
change this unit's system frequency setting (see
page 40).
Check the signals being input to this unit.
Recording on a media is not possible because a
buffer overflow has occurred in the recording buffer
memory.
An attempt has been made to carry out a recording
operation when the playback port is selected.
Select the recording port.
The length of the clip has reached the maximum limit
during recording. Recording will stop within the next
two minutes.
The total recording time has reached the maximum
limit during recording. Recording will stop within the
next two minutes.
125
Troubleshooting