Sony XDS-1000 Operation Manual page 114

Item
M37: AUDIO M370: HEAD ROOM
CONFIG
M371: DATA LEN
M372: NON-AUDIO
INPUT
Sub-item
1
2
3
4
M373: IN LEVEL
Sub-item
1
2
M377: OUT LEVEL
M39: OTHER M391: VITC REC
CONFIG
M395: FRMT MEDIA
M397: PORT
CONFIGURATION
M398: VDCP STATUS
MODE
M3A: GPIO SETUP
Sub-item
114
Maintenance Menu
M3: OTHERS: Other setting items
Setting
Select the audio reference level (headroom).
–20dB, –18dB, –16dB, –12dB, EBUL
Note
EBUL can be selected only when the system frequency is 50i/25P.
Select the audio channel configuration for IMX recording.
16bit x 8ch [16x8]: 16-bit, 8-channel configuration
24bit x 4ch [24x4]: 24-bit, 4-channel configuration
Select whether to handle digital audio signals as non-audio signals during
recording.
audio [Audio]: Handle as linear PCM audio signals.
data: Handle as non-audio signals.
Tr1/Tr2
Tr3/Tr4
Tr5/Tr6
Tr7/Tr8
Set the upper limit for the signal level input to audio channels 1/3/5/7 or 2/4/6/8.
+4dB, 0dB, –3dB, –6dB, EBUL
CH1/3/5/7
Note
CH2/4/6/8
EBUL can be selected only when the system frequency is 50i/25P.
Set the reference level for audio output signals.
+4dB, 0dB, –3dB, –6dB, EBUL
Note
EBUL can be selected only when the system frequency is 50i/25P.
Select whether to record the VITC in the input HDSDI signals in the LTC user bits
area.
disable [dis]: Do not record.
enable [ena]: Record.
Specify whether to disable the Format Media command of the Clip Menu.
disable [dis]: Disable the Format Media command.
enable [ena]: Enable the Format Media command.
Set the port operation mode.
1-in/1-out mode [i/o]: Ports operate independently.
VTR mode [vtr]: Ports operate together as input and output connectors.
Set the operations to reflect in the VDCP status.
VDCP [vdc]: Only operations via VDCP are reflected in the VDCP status.
VDCP/FP/NetRMT [all]: Operations from VDCP, remote connection, and the
front panel are reflected in the VDCP status.
Set commands and statuses to be assigned to the pins of the GPIO connector.
off: Do not assign any command or status.
Commands to be assigned to pins IN 1 to IN 4:
PB-STOP COMMAND [P.STP]: STOP command to the playback port
PB-PLAY COMMAND [PLAY]: PLAY command to the playback port
PB-RECUE COMMAND [RECUE]: RECUE command to the playback port
REC-STOP COMMAND [R.STP]: STOP command to the recording port
REC-REC COMMAND [REC]: REC command to the recording port
Statuses to be assigned to pins OUT 1 to OUT 4:
ALARM STATUS [ALARM]: Status of the alarm (ON when an error occurs)
ALARM2 STATUS [ALARM2]: Status of the alarm 2 (ON when an error or
warning occurs)
PB-STOP STATUS [P.STP]: Stop status of the playback port
PB-PLAY STATUS [PLAY]: Playback status of the playback port
REC-REC STATUS [REC]: Recording status of the recording port