Sony XDS-1000 Operation Manual page 127

Alarm message in clip
list screen
One Clip is being
Recorded.
Use Single Selection.
Operation is not
Supported for EDL.
Adding EM was not
Performed.
Over DUR!
Cannot Display Chapter of
this Clip.
Chapter was Changed.
Display Again.
Chapter does not Exist.
Cannot Expand this Clip.
Unable to Parse the EDL.
Out of Remain Space!
Alarms relating to audio and video signals
Alarm message in status Alarm message in video monitor screen Description/action
display area
No INPUT! INPUT VIDEO IS NOT DETECTED.
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
EMPHASIS! INPUT AUDIO EMPHASIS IS NOT
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
REF Not Exist –
REF NON-STD A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO.
USE A STANDARD SIGNAL.
Alarms relating to sensors
Alarm message in status Alarm message in video monitor screen Description/action
display area
FAN(1/2) Error FAN(1/2) ERROR.
FAN(1/2) Warning FAN(1/2) WARNING.
DC Power Warning DC POWER STATUS IS NOT NORMAL.
PLEASE CONTACT SERVICE.
Power Unit(A/B) Err! POWER SUPPLY UNIT(A/B) STATUS IS
NOT NORMAL. PLEASE CONTACT
SERVICE.
High TEMP! HIGH TEMPERATURE.
Low TEMP! LOW TEMPERATURE.
Description/action
One of the selected clips was being recorded.
To copy a clip which is being recorded, make a single selection of the clip.
You cannot select EDL to delete an essence mark or set a shot mark.
Essence mark setting has failed.
A clip with a duration that exceeds six hours cannot be copied.
The selected clip has failed in chapter thumbnail display.
Stop recording of a clip if any in progress.
The chapter setting information has been updated.
Try again the chapter thumbnail display.
Chapter thumbnail screen cannot be displayed because no chapters are set on the clip.
The clip cannot be expanded because it is being recorded.
The EDL cannot be copied due to existence of an inhibiting condition such that there is no sub clip.
The remaining capacity of the copy destination media is not sufficient.
• Check the setting of V INPUT on page P1 INPUT of
the function menu (see page 45).
• Input an HD-SDI signal.
Check the emphasis of the audio input signal.
Input a reference signal.
Input a standard reference signal.
Contact your Sony service or sales representative.
Note
The unit will not stop operating, but if you continue to
use it in this state, temperatures inside the unit will
rise, possibly resulting in failure or fire.
The unit is being used in a low-temperature
environment.
Note
The unit will operate, but the performance of the hard
disk drives will decline, possibly affecting recording or
playback.
127
Troubleshooting