Korg Electronic Keyboard Parameter Manual page 72

Program mode: HD-1
Resonance
Low resonance value
Resonance
Resonance emphasizes the frequencies around the
cutoff frequency.
When this is set to 0, there is no emphasis, and
frequencies beyond the cutoff will simply diminish
smoothly.
At medium settings, the resonance will alter the timbre
of the filter, making it sound more nasal, or more
extreme.
At very high settings, the resonance can be heard as a
separate, whistling pitch.
To make the resonance track the keyboard pitch, see
"Key Follow," on page 65.
AMS (Resonance)
This selects a modulation source to control the
Resonance amount. For a list of AMS sources, see
"AMS (Alternate Modulation Source) List" on
page 967.
Intensity
This controls the depth and direction of the Resonance
modulation.
For example, if Velocity has been selected, changes in
keyboard velocity will affect the resonance. With
positive (+) values, the resonance will increase as you
play more strongly, and as you play more softly the
resonance will approach the level specified by the
Resonance setting. With negative (–) values, the
resonance will decrease as you play more strongly, and
as you play more softly the resonance will approach
the level specified by the Resonance setting.
The resonance level is determined by adding the
Resonance and Intensity values.
Output Level
This controls the output level of Filter A. You can use
this to balance the volumes of Filters A and B when the
Routing is set to Parallel, or to turn down the volume
to avoid clipping later in the signal chain.
AMS (Output Level)
This selects a modulation source to control the output
level of Filter A. For a list of AMS sources, see "AMS
(Alternate Modulation Source) List" on page 967.
Intensity
This controls the depth and direction of the output
level modulation.
3–1c: Filter B
Filter B is available when the Filter Routing is set to
Serial or Parallel. Otherwise, the parameters in this
section will be grayed out.
62
[00...99]
[List of AMS Sources]
[–99...+99]
[00...99]
[List of AMS Sources]
[–99...+99]
The parameters for Filter B are identical to those for
Filter A. For more information, see the descriptions
under Filter A, above.
▼ 3–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Program. For more information, see "Write
Program" on page 138.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Copy Oscillator. For more information, see
"Copy Oscillator" on page 144.
• 3: Swap Oscillators. For more information, see
"Swap Oscillator" on page 144.
High resonance value