046: Ensemble - Korg Electronic Keyboard Parameter Manual

Effect Guide
LFO2 Amount
This sets the LFO2 Frequency modulation amount, in
Hz.
MIDI/Tempo Sync
BPM
LFO1 Note
Times
LFO2 Note
Times
When MIDI/Tempo Sync is on, the LFO speeds are set
by BPM, Note, and Times, instead of Frequency. The
two LFOs each have their own settings for Note and
Times. For more information, see "MIDI/Tempo Sync"
on page 777.
MODE
Chorus 1 and 2 are connected as shown in the diagram.
Routing: Dual
Output Mode: Mono
Output Level1/2

046: Ensemble

This Ensemble effect has three chorus blocks that use
LFO to create subtle shimmering, and gives three
dimensional depth and spread to the sound, because
the signal is output from the left, right, and center.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Right
Shimmer
LFO
ENSEMBLE
Depth
Sets the depth of the LFO modulation.
Source
Selects the modulation source for the LFO depth.
Amount
Sets the modulation amount of the LFO modulation
depth.
LFO
Speed
Sets the LFO speed.
802
[–20.00...+20.00]
[Check-box]
[MIDI, 40.00...240.00]
[x1...x32]
[x1...x32]
Routing / Output Mode / Output Level 1/2
Routing: Dual Routing: Serial
Output Mode: Stereo
Output Level1/2
Ensemble
[0...100]
[Off...Tempo]
[+/–100]
[1...100]
Routing
Selects parallel or serial connection for chorus 1 and 2.
If Routing is set to Serial, the Chorus 1 Output Level,
Chorus 2 Output Level, and Chorus 2 Feedback
settings are ignored.
Output Mode
[ ... ]
This applies only when Routing is set to Dual.
Mono: The outputs of both chorus 1 and 2 are summed
together and panned to the center.
[ ... ]
Stereo: Chorus 1 goes to the left output, and chorus 2
goes to the right output.
Chorus1 Output Level
Sets the output level for chorus 1.
Chorus2 Output Level
Sets the output level for chorus 2.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Source
Selects a modulation source for LFO speed.
Amount
Sets the modulation amount of LFO speed.
Shimmer
Wet / Dry
This parameter sets the amount of shimmering of the
LFO waveform. Increasing this value adds more
shimmering, making the chorus effect more complex
and richer.
Wet / Dry
Level
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
[Dual, Serial]
[Mono, Stereo]
[0...100]
[0...100]
[Off...Tempo]
[+/–100]
[0...100]
Ensemble LFO
Shimmer
Time