Korg Electronic Keyboard Parameter Manual page 614

Sampling mode
(In the same way, the on/off settings for MFX1, 2 and
TFX1, 2 will also be turned off.) Be aware of this if you
want to sample once again.
8–1c: FX Control Bus
FX Control Bus
This sends the output of the oscillator (multisample) to
a FX Control bus (stereo 2-channel; FX Ctrl1, 2)
Use the FX Control buses when you want to use a
separate sound to control the input of an effect. You
can use the two (stereo 2-channel) buses to control
effects freely.
For more information, please see "FX Control Bus" on
page 574.
8–1d: REC Bus
REC Bus (All OSCs to)
This sends the output of the oscillator (multisample) to
the REC buses (four mono channels; 1...4). If you want
to resample from the REC buses, set Source Bus to
REC1/2 or REC3/4.
The REC buses are used to sample in each mode, and
to record audio tracks in Sequencer mode. They are
dedicated buses for recording.
Off: The oscillator output will not be sent to the REC
buses. Normally you will leave this Off.
1...4: The oscillator output will be sent in monaural to
the corresponding REC bus.
1/2, 3/4: The oscillator output will be sent in stereo to
the corresponding pair of REC buses.
8–1e: OSC MFX Send
Send1 (to MFX1)
Send2 (to MFX1)
This sets the send levels at which the output of the
oscillator (multisample) is sent to the master effects.
The master effects are sent to the L/R bus. Set the
Source Bus to L/R if you want to use master effects
while resampling.
You can use CC#93 to control the Send 1 level and
CC#91 to control the Send 2 level. The global MIDI
channel specified by MIDI Channel (Global 1–1a) is
used for these messages.
8–1f: Tempo
(Tempo)
This is the Global tempo, as used for controlling
effects, etc.
▼ 8–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
604
[Off, 1, 2]
[Off, 1...4, 1/2, 3/4]
[000...127]
[000...127]
[040.00...240.00, EXT]
• 0: Copy Insert Effect. For more information, see
"Copy Insert Effect" on page 149.
• 1: Swap Insert Effect. For more information, see
"Swap Insert Effect" on page 150.
For more information, please see "Sampling: Page
Menu Commands" on page 615.