087: Reverse Delay - Korg Electronic Keyboard Parameter Manual

BAND4 LFO
Band 4's LFO has the same parameters as the "BAND1
LFO," above.

087: Reverse Delay

This is a delay that plays back the input signal in
reverse. You can also continue feedback while
alternating playing the signal in reverse and forward
directions.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Feedback
Feedback
+
Reverse
Trim Sync High Damp
Right
D -mod
Trigger
INPUT
Input Level Dmod [%]
Sets the modulation amount of the input level.
Source
Selects the modulation source for the input level.
REVERSE DELAY
Reverse Time [msec]
Sets the length of reverse playback (= delay time).
p.837.
Level
Sets the output level of the reverse playback.
L Post-Delay Time [msec]
Sets the delay time of the Left Tap.
Level
Sets the output level of the Left Tap.
R Post-Delay Time [msec]
Sets the delay time of the Right Tap.
Level
Sets the output level of the Right Tap.
Feedback Mode [Reverse, Reverse/Forward]
Reverse: the feedback plays in reverse.
Reverse/Forward: the feedback alternates between
playing backwards and forwards, as shown below.
Wet / Dry
Feedback Mode
Delay
Level
Wet / Dry
[+/–100]
[Off...Tempo]
[0...900]
[0...100]
[0...900]
[0...100]
[0...900]
[0...100]
Delay
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Input
Feedback Mode: Revese
wet
Feedback Mode: Revese/Forward
wet
Feedback
Sets the feedback amount.
Source
Selects the modulation source of feedback amount.
Amount
Sets the feedback amount.
High Damp [%]
Sets the damping amount in the high range.
Sync Source
Selects the modulation source that will reset the point
at which the sound is captured for reverse playback.
p.837.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
REVERSE DELAY: Reverse Time and Sync Source
The sound will be played in reverse for the duration
specified by Reverse Time. You can reset the dividing
point for reverse playback by specifying a modulation
source for Sync Source.
Reverse Time
Input
wet
Reverse Time
087: Reverse Delay
Feedback Mode
Time
[+/–100]
[Off...Tempo]
[+/–100]
[0...100]
[Off...Tempo]
Reverse Time/Sync
Sync
reset
Time
837