Examples of the effect graphics
Here are some examples of the effects that display
graphics.
Purple area: This shows the frequency response
after passing through all of the bands.
Vertical axis: Gain (dB)
Horizontal axis:
Frequency (Hz)
These sliders adjust the
gain (dB) of each band.
This line shows the center
frequencies of the selected Type.
Parametric EQ/EQ
Parametric EQ/EQ is used in 011: Stereo Parametric
4EQ, 013: Stereo Master 3EQ, 027: OD/Hi-Gain Wah,
030: Guitar Amp Model+P4EQ, and the "P4EQ" and
"OD/Hi Gain" of Mono-Mono Serial and
Mono//Mono Parallel effects #109 and following.
Purple line:
• This indicates the frequency
response after passing
through bands 1, 2, 3, and 4.
• The Trim setting is not shown.
Vertical axis: Gain (dB)
Horizontal axis: Cutoff frequency (Hz)
Examples of the effect graphics
012: Stereo Graphic EQ
Red lines show the center frequencies of each band.
The cutoff frequencies specified for bands 1, 2, 3, and 4 are shown by red lines.
Individual Outputs
The selected band
is indicated by a
thick red line.
Green line: Shows
the frequency response
of the selected band
alone, without the results
of the other bands.
The currently selected band
is shown by a thick red line.
759