132: Od/Hi Gain - Phaser - Korg Electronic Keyboard Parameter Manual

Effect Guide
Drive
Sets the degree of distortion.
Output Level
Sets the overdrive output level.
Source
Selects the modulation source for the overdrive output
level.
Amount
Sets the modulation amount of the overdrive output
level.
EQ
Low Fc [Hz]
Sets the center frequency for Low EQ (shelving type).
Gain [dB]
Sets the gain of the Low EQ.
Mid1 Fc [Hz]
Sets the center frequency for Mid/High EQ 1 (peaking
type).
Q
Sets the band width of Mid/High EQ 1. p.773.
Gain [dB]
Sets the gain of Mid/High EQ 1.
Mid2 Fc [Hz]
Sets the center frequency for Mid/High EQ 2 (peaking
type).
Q
Sets the band width of Mid/High EQ 2. p.773.
Gain [dB]
Sets the gain of Mid/High EQ 2.

132: OD/Hi Gain - Phaser

This effect combines a mono overdrive/high-gain
distortion and a phaser. You can change the order of
the effects.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Overdrive / Hi-Gain
3 Band PEQ
+
Driver
Output Level
Mode: Overdrive / Hi-Gain
Drive
Right
870
[1...100]
[0...50]
[Off...Tempo]
[–50...+50]
[20...1.00k]
[–18...+18]
[300...10.00k]
[0.5...10.0]
[–18...+18]
[500...20.00k]
[0.5...10.0]
[–18...+18]
Wet / Dry
Routing
Phaser
Phaser
Normal
+
Output Mode
—
Wet Invert
Resonance
Phaser Wet / Dry
Wet / Dry
LFO: Tri / Sine
CHORUS/FLANGER
LFO
Waveform
Selects the LFO Waveform.
Frequency [Hz]
Sets the LFO speed.
FLANGER
Delay Time [msec]
Sets the delay time.
Depth
Sets the depth of LFO modulation.
Feedback
Sets the feedback amount. p.803.
Output Mode
Selects whether the chorus/flanger output is mono or
pseudo-stereo. For more information, see "Output
Mode" on page 857.
When Routing is set to Flanger→ → → → OD/HG, Output
Mode will automatically be set to Normal.
Wet/Dry
Sets the effect balance of the chorus/flanger. p.780,
p.804.
Source
Selects the Wet/Dry modulation source for the
chorus/flanger.
Amount
Sets the Wet/Dry modulation amount for the
chorus/flanger.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Routing
[OD/HG ➝ Phaser, Phaser ➝ OD/HG]
Routing
Switches the order of the overdrive and phaser.
OD/HI-GAIN
DRIVE
For more information on these parameters, see
"DRIVE" on page 788.
Drive Mode
Switches between overdrive and high-gain distortion.
[Triangle, Sine]
[0.02...20.00]
[0.0...1350.0]
[0...100]
[+/–100]
[Normal, Wet Invert]
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[+/–100]
[Overdrive, Hi-Gain]