099: Reverse Bpm Delay - Korg Electronic Keyboard Parameter Manual

Effect Guide
Source
Selects the modulation source for the Feedback Level.
Amount
Sets the modulation amount for the Feedback Level.
Tone
High Damp [%]
This cuts the high frequencies in both the main output
and the feedback. Higher settings create a darker tone.

099: Reverse BPM Delay

This is a reverse-playback delay that lets you
synchronize the delay time to the tempo of the song.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Feedback
+
Reverse
Trim Sync
Right
D -mod
Trigger
BPM
Tempo
Base Note x Times
Base Note x Times
BPM
Base Note x Times
INPUT
Input Level Dmod [%]
Sets the modulation amount of the input level.
Source
Selects the modulation source for the input level.
REVERSE DELAY
BPM
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect. p.822.
Time Over? >
The maximum delay time is 900msec. If the
combination of BPM, Base Note, and Times exceeds
this limit, the error message "OVER!" will appear. If
this occurs, change the delay time parameters so that
this message no longer appears.
Reverse Base Note
Selects the note value used to specify the length of
reverse playback (= delay time). p.822
Times
Sets the number of notes to specify the delay time.
p.822.
Level
Sets the output level of the reverse playback.
848
[Off...Tempo]
[+/–100]
[0...100]
Wet / Dry
Feedback Mode
Feedback
Delay
High Damp
Level
Wet / Dry
[+/–100]
[Off...Tempo]
[MIDI, 40.00...240.00]
[---, OVER!]
[ ... ]
[x1...x32]
[0...100]
Low Damp [%]
This cuts the low frequencies in both the main output
and the feedback. Higher settings mean less low-end.
Saturation
This models the distortion of an analog tape delay.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
L Post-Delay Base Note
Selects the type of notes to specify the delay time for
the Left Tap. p.822.
Times
Sets the number of notes to specify the delay time for
the Left Tap. p.822.
Level
Sets the output level of the Left Tap.
R Post-Delay Base Note
Selects the type of notes to specify the delay time for
the Right Tap. p.822
Times
Sets the number of notes to specify the delay time for
the Right Tap. p.822.
Level
Sets the output level of the Right Tap.
Feedback Mode [Reverse, Reverse/Forward]
Selects the feedback mode: reverse playback, or
alternating reverse and forward playback. p.837.
Feedback
Sets the feedback amount.
Source
Selects the modulation source of feedback amount.
Amount
Sets the feedback amount.
High Damp [%]
Sets the damping amount in the high range.
Sync Source
Selects the modulation source that will reset the point
at which the sound is captured for reverse playback.
p.837.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
[0...100]
[0...100]
[ ... ]
[x1...x32]
[0...100]
[ ... ]
[x1...x32]
[0...100]
[+/–100]
[Off...Tempo]
[+/–100]
[0...100]
[Off...Tempo]