Table of Contents
Advertisement
4-5c: Decay
Decay
This controls the overall decay time of the string
without affecting frequency content. This interacts
with Damping, which controls the decay time for high
frequencies. For more information, see "4-6a:
Damping" on page 252.
Note: the Amp EG still controls the output level of the
STR-1 as a whole, so the final decay time will be a
combination of the String Decay and the Amp EG. As
a general rule, the Amp EG can make the overall decay
time shorter than the String Decay, but not longer.
For instance, if the String Decay is set to a high value
(for a long decay), but the Amp EG Decay is short, the
final result will be a short decay.
For more information, see "6-3: Amp EG" on page 272.
AMS 1
This selects the first modulation source to control the
Decay. For a list of AMS sources, see "AMS (Alternate
Modulation Source) List" on page 967.
Intensity
This controls the depth and direction of AMS1.
AMS 2
This selects a second modulation source to control the
Decay. For a list of AMS sources, see "AMS (Alternate
Modulation Source) List" on page 967.
Intensity
This controls the depth and direction of AMS 2.
Release
This sets the overall release time for the string–the time
that it takes to fade away after note-off.
Note: the Amp EG still controls the output level of the
STR-1 as a whole, so the final release time will be a
combination of the String Release and the Amp EG.
For more information, see "Decay," above.
AMS
This selects a modulation source to control the Release.
For a list of AMS sources, see "AMS (Alternate
Modulation Source) List" on page 967.
Intensity
This controls the depth and direction of the Release
modulation.
4-5d: Nonlinearity
Amount
This models the instability of the string's bridge.
Greater nonlinearity means a less rigid bridge. At
higher levels, this causes the characteristic buzzing
sound of some non-western stringed instruments, such
as the sitar.
[0...100]
[List of AMS Sources]
[-100...+100]
[List of AMS Sources]
[-100...+100]
[0...100]
[List of AMS Sources]
[-100...+100]
[-100.0...100.0]
Program P4: String
AMS1
This selects the first modulation source to control the
Nonlinearity. For a list of AMS sources, see "AMS
(Alternate Modulation Source) List" on page 967.
Intensity
This controls the depth and direction of the
Nonlinearity modulation.
AMS2
This selects a second modulation source to control the
Nonlinearity. For a list of AMS sources, see "AMS
(Alternate Modulation Source) List" on page 967.
Intensity
This controls the depth and direction of the second
Nonlinearity modulation.
▼ 4–5: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Program. For more information, see "Write
Program" on page 138.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
4-5: String Main
[List of AMS Sources]
[-100.0...+100.0]
[List of AMS Sources]
[-100.0...+100.0]
251
Advertisement
Table of Contents
