Calls Cannot Be Sent - Konica Minolta bizhub 160f User Manual

8

Calls cannot be sent

Symptom
Nothing can be heard from the
connected telephone.
After dialing, the ringing can-
not be heard.
After the [Speaker] key is
pressed, it is difficult to hear
the recipient/caller's voice.
The ringing of the telephone is
too low (loud).
8-36
Possible cause
The cord from the telephone is
not connected correctly to the
main unit.
The telephone cord from the
wall jack is not connected cor-
rectly to the main unit.
Transmitting.
The telephone dialing system
(TONE/PULSE) is not set cor-
rectly.
The telephone wiring system
(PSTN/PBX) is not set correct-
ly.
The monitoring volume is too
low.
The ringer volume of the con-
nected telephone is set too
low (loud).
When a message appears
Remedy
Correctly connect the tele-
phone cord to the main unit.
Correctly connect the tele-
phone cord from the wall jack
to the main unit.
Check again after the trans-
mission is finished.
Correctly set the telephone di-
aling system. (p. 7-71)
Correctly set the telephone
wiring system. (p. 7-73)
Increase the monitoring vol-
ume. (p. 7-72)
Adjust the ringer volume of the
connected telephone.
bizhub 160f