7
7.9
Communication settings
From the COMM.SETTING menu, various functions are available for specify-
ing communication settings.
No.
COMM.SETTING
1
TONE/PULSE
2
LINE MONITOR
3
PSTN/PBX
Selecting the COMM. SETTING menu
1
Press the [Utility] key nine times.
COMM. SETTING
2
From the 10-key pad, press the key
([1] through [3]) for the communica-
tion setting function that you wish to
set.
The communication setting functions
are as follows:
1 TONE/PULSE
2 LINE MONITOR
3 PSTN/PBX
Note
If, at any time, you wish to quit setting/changing an communication set-
ting function, press the [No/C] key. When the message
appears, press the [Yes] key to quit.
To exit the COMM. SETTING menu, press the [Panel reset] key. The main
screen appears again.
7-70
Characteristic/Description
This function can be used to specify the dialing system. If this
function is not correctly set to the type of dialing system used,
faxes cannot be sent. Select the correct setting after checking
which type of dialing system is used by your telephone line.
This function can be used to set the volume when monitoring
communication to "HIGH", "LOW" or "OFF".
• Default setting: LOW.
This function can be used to set whether the connected tele-
phone wiring is a public switched telephone network (PSTN) or a
private branch exchange (PBX).
For a PBX system, the outside line access number (or extension
number) must be specified.
appears.
Using the utility mode
STOP SETTING?
bizhub 160f