The Machine Is Not Functioning As Designed - Konica Minolta bizhub 160f User Manual

When a message appears
8.11

The machine is not functioning as designed

Symptom
Nothing appears in the dis-
play.
The [Start] key indicator does
not light up green.
The machine does not oper-
ate when it is turned on.
* If the problem is not corrected even after the operations described are performed, turn off the
machine, unplug its power cord, and then contact the service representative.
bizhub 160f
Possible cause
Is only the [Start] key lit green?
Has the machine been turned
on?
Is the contrast of the display
too light?
The machine has just been
turned on and is warming up.
The power cord is left un-
plugged.
The room's circuit breaker is
open.
Action
The energy save mode is ena-
bled. Press any key on the
control panel to cancel energy
save mode.
Check that the power cord is
firmly connected and that the |
(on) side of the power switch
has been pressed.
From the machine setting
menu of the utility mode, ad-
just the display to the correct
contrast. Refer to "Specifying
LCD CONTRAST" on
page 7-10.
It takes the machine less than
25 seconds to be ready to
make copies after it has been
turned on.
Please wait.
Plug the power cord into the
power outlet.
Close the room's circuit
breaker.
8
8-33