Konica Minolta bizhub 160f User Manual page 273

When a message appears
Message
LINE PROBLEM
(Flashing alternately)
CHECK LINE
*COMM.ERROR*
(####)
*REDIAL ALL FAILED*
*MEM.FULL/TX CANCEL*
*MEM.FULL/RX CANCEL*
FILE FULL/TX CANCEL
FILE FULL/RX CANCEL
HANG UP THE PHONE
TEXT ×1.00
¦[A]§ #XXX: EMPTY
TEXT ×1.00
¦[A]§ #XXX: Fax Err
TEXT ×1.00
¦[A]§ #XXX: Comm.Err
bizhub 160f
Cause
The telephone dialing system
or telephone wiring system
are not set correctly.
The telephone cable is not
attached correctly.
Communication is not possi-
ble because of some prob-
lem in the machine.
Communication is not possi-
ble because of a problem
with the recipient/caller's fax
machine.
All redial attempts failed be-
cause either the recipient's
line is busy or there was no
answer.
While sending a fax, the size
of the data for the scanned
image has exceeded the ca-
pacity of the memory.
While receiving a fax, the size
of the data for the received
image has exceeded the ca-
pacity of the memory.
While sending a fax, the
maximum of number of man-
aged memory file is used.
While receiving a fax, the
maximum of number of man-
aged memory file is used.
The receiver of the connect-
ed telephone is lifted.
1 (While specifying copy set-
tings)
The selected paper tray has
run out of paper.
"#" indicates the paper tray,
and "XXX" indicates the pa-
per size.
1 A fax error occurred while an
operation was being per-
formed in Copy mode.
1 A fax transmission error oc-
curred while an operation
was being performed in
Copy mode.
Action
Check the telephone dialing
system or telephone wiring
system and use the appro-
priate Utility mode function
to make the correct settings.
Correctly connect the tele-
phone cable.
Check the transmission re-
sults.
Check the condition of the
recipient's line, and then try
sending the fax again.
Retrieve all received faxes
stored in the memory.
Send the fax by direct trans-
mission.
Retrieve all received faxes
stored in the memory.
Retrieve all received faxes
stored in the memory.
Retrieve all received faxes
stored in the memory.
Replace the receiver of the
connected telephone on the
hook.
Either load paper of the
specified size into the speci-
fied paper tray, or press the
[Paper] key and select a dif-
ferent paper size.
Press the [Fax] key to check
the error condition, and take
appropriate measures.
Press the [Fax] key to check
the error condition, and take
appropriate measures.
8-29
8