Before Starting Remote-Control Operations - Yaesu WIRES-X HRI-200 Instruction Manual

Before starting remote-control operations

Since the WIRES-X software does not to accept remote-control operations by default, the setting must be changed before remote-
control operations can begin.
Also, the Internet environment of the node station must be setup in advance to accept remote-control operations.
● Opening the communication ports
When using the web monitoring function, the PC for remote-control operations communicates with the node PC via the specified
TCP port (46190).
When using a router to connect your PC to the Internet, the TCP port must go through the router as well; however, communications
using this port is generally prohibited on commercially available routers in the default setting.
Therefore, if you are using a router, make sure that the TCP ports are "open" for passing TCP traffic.
Register the TCP port 46190 for the router setting such as "NAT" or "Port mapping". Use the address set in "Setting an IP address
on the PC" (page 15) for the LAN side.
For the detailed procedure, refer to the instruction manual supplied with your device.
● Configuring the WIRES-X software setting
Set the WIRES-X software in advance to accept remote-control operations.
1
Start the WIRES-X software
2
From the "File" menu, click "Settings"
The "Settings" window will appear.
3
Click "General settings" under "Property"
On the "Settings" window, the "General settings" screen will appear.
4
Put a check-mark in the "Remote control" checkbox
5
Enter your new password in the "Password" box
6
Click [OK]
The WIRES-X software is ready to accept remote-control operations.
How to Use
Advanced Operations
49