Yaesu WIRES-X HRI-200 Instruction Manual page 80

● Call settings
Round QSO Room connection ....................Set the operation when receiving a connection request to a room on the Internet.
Accept calls while in Round QSO Rooms ...Set the operation when receiving a connection request from another node while
Back to Round QSO after disconnect ..........Set the operation when the connection is severed from the node after accepting its
Return to Room ...........................................Set whether or not to connect to the room specified from "Room ID" every time.
WIRES-X Software
ON (with a check-mark) .......... Allows the connection to a room when requested
OFF (without a check-mark) ... Rejects the connection when requested.
Caution When the "Return to Room" checkbox is checked and a connection room is set,
the connection will be initiated automatically regardless of the "Round QSO Room
connection" setting.
connecting to a room on the Internet.
ON (with a check-mark) .......... Severs the connection to the room and initiate the
OFF (without a check-mark) ... Rejects the request (keeps the connection to the
Caution If a connection request is received while nodes on the room are communicating, the
request is rejected regardless of this setting.
connection request while "Accept calls while in Round QSO Rooms" is set to ON.
ON (with a check-mark)
OFF(without a check-mark)
ON (with a check-mark) .......... Connects to the specified room every time the
OFF (without a check-mark) ... Connects to the specified room not every time
Tip
The #55555 command can also change this setting (When "DTMF #55555" is set to ON).
The operating conditions are as follows when this function is set to ON.
• Connecting time belt ... 24 hours
• Maximum number of times for retrying connection
..................................... 10 times (If connection cannot be established after sending
connection requests 10 times, set the function to OFF. To
(default setting).
connection to the node when requested.
room) (default setting).
Reconnects to the room your node was connected to
before accepting the interrupt connection request.
Does not reconnect to the room (remains in not
connected mode) (default setting).
WIRES-X software starts.
(default setting).
Main Menu
80