Dtmf Commad List - Yaesu WIRES-X HRI-200 Instruction Manual

DTMF Commad List

The following table shows the DTMF commands supported by WIRES-X and operations of the WIRES-X software when receiving
these commands.
Tip
A communication using DTMF is available only when setting the transceiver for an analog operation.
Command
#55555 Always connect your node to the
specified room
#66666 Inquire about the operating status
of your node
#99999 Sever a connection
*
Function
If the node receives this command when the node is not connected to
another node or room, the function that connects the node to the specified
room will be activated. Receiving this command again will deactivate the
function.
When your node is connected to another node or room or set to transmission
cancellation mode (during "ON-AIR LOCK"), the WIRES-X software will not
react to this command.
The setting status can be confirmed on the "Call settings" screen in the
"Settings" window displayed from the "File" menu - "Settings". You can also
change the setting on the screen.
Caution
Tip
Announces your call sign and the operating status ("Not connected" or
"Connected to ***** (DTMF ID of the connection destination)") as a response
to the command.
Cautions
If the node receives this command when the node is not connected to
another node or room, the connection will be severed.
Caution
Appendix
WIRES-X software operation when receiving the command
This command can be accepted only when the "DTMF #55555" checkbox is
checked on the "Call settings" screen in the "Settings" window.
While operating in analog mode, an announcement can be transmitted as a
response to this command. To transmit the response announcement, from the
"File" menu, select "Settings" and display the "Settings" window, then on the
"General settings" screen, insert a check-mark in the "DTMF #55555" checkbox.
• The announcement is transmitted as a response to this command only
during an analog operation.
• To transmit the response announcement, from the "File" menu, select
"Settings" and display the "Settings" window, then on the "General settings"
screen, insert a check-mark in the "DTMF #66666" checkbox.
To accept the * command, from the "File" menu, select "Settings" and
display the "Settings" window, then on the "General settings" screen, insert a
check-mark in the "DTMF * Disconnect" checkbox.
103