Volume Adjustment - Yaesu WIRES-X HRI-200 Instruction Manual

Latitude/Longitude ......................Location information of your node
[Read GPS data] ........................When using a transceiver compatible with the HRI-200 control mode and the GPS satellite
Show position data .....................Put a check-mark to show the location information when your node is shown on the node list

Volume adjustment

When operating an analog node or connecting to an analog node, to operate with proper sound levels, the volume level must be
adjusted in advance.
Tip
For communications between digital nodes, the volume level adjustment is not required. The following volume level setting has no affect digital
communications.
● When using an HRI-200 mode compatible C4FM digital transceiver (FTM-400DR)
1
From the "View" menu, click "Audio adjustment"
The "Audio adjustment" window will appear.
2
From the "Settings" menu, click "Preset Volume" - "HRI-200
mode Transceiver"
3
Click [Close]
The setting will be stored and the proper sound volume will be
set.
How to Use
Tip
Enter values based on the location information of world geodetic system (WGS-84).
information is acquirable, the GPS location information can be read from the transceiver. Click
this option to replace the location information setting on your node with the GPS location
information received from the transceiver.
of the WIRES-X server. The location information will be sent to digital nodes connected to your
node as well.
Basic Operations
27