Receiver Connections - Extron electronics eLink 100 User Manual

Receiver Connections

Figure 3.
IR sensor — Receives IR commands from the included IR remote control unit and the
A
IR remote of the source device.
NOTES:
•
•
USB Power connector — Connect the USB end of the provided 5 V jack-to-USB
B
adapter to this USB mini-B connector. Connect the other end of the adapter to the
provided 5 VDC power supply.
NOTE: Use only the power supply provided by Extron. See the
next page for important information.
NOTE: Snap the included
ferrite bead onto the
power supply cable at a
distance of 3.25 inches
(8.25 cm) from the end
of the DC connector.
HDMI Out connector — Connect an HDMI cable between this port and the HDMI
C
input connector of the display device.
eLink 100 R Receiver Side Panel
The IR sensor is compatible only with 38 kHz IR carrier frequency. See the
specifications for the IR remote of the source device or contact the device
manufacturer to verify the compatibility of the IR remote frequency.
Make sure that the receiver IR sensor faces forward if using a source device IR
remote to pass signals back to the transmitter. Wall mounting or concealing the
receiver causes the IR sensor to be unreachable.
eLink 100 HDMI Transmitter and Receiver • Installation
B B
HDMI
5V
1.5A MAX
HDMI OUT
POWER
Back Panel
Attention
To Power Supply
To USB Power
Connector on
Receiver.
3.25 inches
(8.25 cm)
on the
6