e
Power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver
page 6). See
NOTES:
Receiver Connections
DTP HDMI 230 Rx Rear Panel
SIG
LINK
POWER
12V
0.7A MAX
DTP IN
10
6
.
Figure 3.
f
DTP Input RJ-45 connector — Connect one end of the TP cable from the transmitter
output connector to this RJ-45 female connector. Ensure the opposite end of this
cable is connected to the transmitter DTP Output RJ-45 connector (see
previous page).
ATTENTION:
NOTE: See
Signal LED — This LED lights when the unit is receiving a TMDS clock signal on the
HDMI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED — This LED lights when a valid link is established between the units on the
DTP input and output cable.
g
HDMI output connector — Connect a display with an HDMI input port (or DVI input
port, with an appropriate adapter) to display the transmitted direct digital image.
Power supply wiring
•
One power supply is included with the transmitter and normally can power
both units.
•
If you have removed the ground jumpers (see
on page 12) because of ground potential differences, one DTP HDMI 230
unit cannot remotely power the other unit. Each unit requires a local power
supply.
OUTPUTS
AUDIO
L
R
7
8
DTP HDMI 230 Rx Connectors
Do not connect this device to a computer data or
telecommunications network.
TP cable termination
connectors and for detailed NOTES.
DTP HDMI 230 Tx/Rx Transmitter and Receiver • Installation and Operation
on page 9 to wire the connector.
Disconnecting the Ground
Front Panel
OVER DTP
RS-232
IR
Tx Rx
G
Tx Rx
9
on page 7 to properly wire the RJ-45
j
(item
on
DTP HDMI 230 Rx
d
item
on the
5