Operating Frequencies - Extron electronics eLink 100 User Manual

Operating Frequencies

The eLink 100 uses DFS (Dynamic Frequency Selection) technology, which actively monitors
the RF spectrum to select the most appropriate frequencies. This prevents interference from
other devices operating in the 5 GHz spectrum.
For reference, the table below lists the operating frequencies and their range (DFS or
Non-DFS).
NOTES:
Frequency
Range
(MHz)
5190
Non-DFS
5230
5270
5310
5510
DFS
5550
5590
5630
5670
5755
Non-DFS
5795
• Up to four transmitter units can operate in the same room or environment. Each
transmitter unit occupies one of these frequencies.
• If a maximum of four transmitters is reached, the next group of units should be
separated to prevent interference (see
Locations on page 17).
• Some WiFi routers and access points also use the 5 GHz frequency band. Monitor
the 5 GHz frequency usage between these products and multiple eLink 100 units,
and plan systems to avoid interference.
eLink 100 HDMI Transmitter and Receiver • Reference Information
Regions
US/Canada Europe
X X
X X
X X
X X
X X
X X
X X
X
X X
X
X
Best Practices for eLink 100 Mounting
Australia
X
X
X
X
X
X
X
19