Table of Contents
Advertisement
Installation
This section provides instructions for installing the eLink 100 extender, including:
•
•
•
•
•
Before Getting Started
If mounting is required before cabling and setting up the eLink 100 units, see
Transmitter and Receiver
ATTENTION:
NOTE: For best performance:
Before Getting Started
Front and Side Panel Features and Connections
Installing the Plug on the Power Supply
The eLink 100 On-Screen Display
Top Panel Features and Functions
on page 15 for mounting instructions.
•
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé
uniquement.
•
These units are not suitable for use in air handling spaces.
•
Ces unites ne sont pas appropriées pour une utilisation dans les espaces
d'aération.
•
Ensure that the installation location is suitable for good signal transmission.
•
For optimal signal range, avoid obstructions, such as walls, furniture or rack
enclosures, between the transmitter and receiver locations. Denser wall materials
can cause signal reduction.
•
Maximum transmission distance is 100 feet (30 meters) with a clear line-of-sight.
•
Up to four transmitter units can operate in the same room or environment. If
a maximum of four transmitters is reached, the next group of units should be
separated to prevent interference (see
Locations
on page 17).
•
Maintain a distance of at least 6.5 feet (2 meters) between multiple eLink
transmitters or multiple eLink receivers. Be mindful of units located beyond walls in
adjacent rooms.
•
Maintain a distance of at least 6.5 feet (2 meters) between the eLink 100 units and
other 5 GHz RF devices. RF products can cause interference or traffic in the 5 GHz
frequency band. Monitor the 5 GHz frequency band and plan systems to avoid
traffic.
•
Do not block the eLink 100 air ventilation openings and ensure proper air ventilation
around the units.
•
Be careful when handling the eLink 100 units as they become hot during operation.
•
Do not install above ceiling tiles. The eLink 100 is not UL Listed for use in plenum
air handling spaces.
Best Practices for eLink 100 Mounting
eLink 100 HDMI Transmitter and Receiver • Installation
Mounting the
4
Hide quick links:
Advertisement
Table of Contents
