Receiver Connections - Extron electronics DTP HDMI 4K 230 User Manual

Hdmi & dvi extenders
Hide thumbs Also See for DTP HDMI 4K 230:
Table of Contents

Advertisement

Receiver Connections

DTP HDMI 4K 230 Rx Rear Panel
SIG
LINK
POWER
12V
0.7A MAX
DTP IN
¢
6
Figure 3.
DTP HDMI 4K 230 Rx Connectors
DTP Input RJ-45 connector — Connect one end of the TP cable from the transmitter output connector to this
6
RJ-45 female connector. Ensure the opposite end of this cable is connected to the transmitter DTP Output
RJ-45 connector (see item
ATTENTION:
ATTENTION : Ne connectez pas cet appareil à un réseau de télécommunications ou de données
informatiques.
NOTE: See
TP cable termination and recommendations
connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a valid signal on the DTP In connector.
Link LED — Indicates a valid link is established between the units on the DTP input and output cable.
HDMI output connector — Connect a display with an HDMI input port (or DVI input port, with an appropriate
7
adapter) to display the transmitted direct digital image.
Audio output connector — This 5-pole, 3.5 mm captive screw connector outputs the transmitted,
8
unamplified, line level analog audio. Connect an audio device, such as an audio amplifier or powered
speakers.
See figure 4 to properly wire a captive screw output connector. Use the supplied tie-wrap to strap the audio
cable to the extended tail of the connector.
Do not tin the wires!
Figure 4.
Captive Screw Connector Wiring for Stereo Audio Output
ATTENTION:
For unbalanced audio, connect the sleeves to the ground contact.
Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS connecter les
manchons aux contacts négatifs (–).
Do NOT connect the sleeves to the negative (-) contacts.
Ne PAS connecter les manchons aux contacts négatifs (–).
OUTPUTS
L
7
on page 5).
4
Do not connect this device to a telecommunications or computer data network.
NO GROUND HERE
Tip
Sleeves
Tip
NO GROUND HERE
Unbalanced Stereo Output
DTP HDMI 4K 230 Tx/Rx Transmitter and Receiver • Installation and Operation
Front Panel
AUDIO
R
8
on page 7 to properly wire the RJ-45
Tip
Ring
Tip
Ring
Balanced Stereo Output
OVER DTP
RS-232
IR
Tx Rx
G
Tx Rx
DTP HDMI 230 Rx
9
6

Advertisement

Table of Contents
loading

Table of Contents