Receiver Connections - Extron electronics DTP DVI 301 User Manual

Receiver Connections

IN
POWER
SIG
12V
0.7 A MAX
DTP IN
ANALOG AUDIO
Rear R Rea r
. 11 7
Figure 3.
g
h
LINK
RS-232 IR
Tx Rx Tx Rx
10
DTP DVI 301 Rx Connectors
DTP and Analog Audio Input RJ-45 connectors — Connect one end of the one
or two separate TP cables from the transmitter output connectors to these RJ-45 female
connectors.
CAUTION: Do not connect this device to a computer data or telecommunications
network.
NOTE: "TP cable
See
detailed NOTES.
å
DTP Input connector (Required) — Ensure the free end of this cable is
connected to the transmitter DTP Out connector
• TMDS (digital) video
• Embedded audio
• Bidirectional RS-232 and IR commands and data
• Remote power
Signal LED — This LED lights when the unit is receiving a TMDS clock signal on
the DVI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED — This LED lights when a valid link is established between the units on
the DTP input and output cable.
ç
Analog Audio Input connector (Optional) — If desired, ensure the free end
of this cable is connected to the transmitter Analog Audio Out connector
This cable carries analog audio only and is not needed for applications that do not
require this audio signal.
DVI-D output connector — Connect a display with a DVI input to display the
transmitted direct digital image. See
assignments.
F ro F Front nt t
termination" to properly wire the RJ-45 connectors and for
(item
"DVI connector pin
DTP DVI 301 • Installation and Operation
OUTPUTS
AUDIO
L R
DVI-D
DTP DVI 301 Rx
8 9
à ). This cable carries:
(item â
assignments" for pin
).
5