Extron electronics USB Extender Plus T User Manual

Extron electronics USB Extender Plus T User Manual

Twisted pair extenders for usb peripherals
Hide thumbs Also See for USB Extender Plus T:

Advertisement

User Guide
USB Extenders
USER MANUAL
USB Extender Plus T/R
Twisted Pair Extenders for USB Peripherals
68-2652-01 Rev. A
12 14

Advertisement

Table of Contents
loading

Summary of Contents for Extron electronics USB Extender Plus T

  • Page 1 User Guide USB Extenders USER MANUAL USB Extender Plus T/R Twisted Pair Extenders for USB Peripherals 68-2652-01 Rev. A 12 14...
  • Page 2: Safety Instructions

    Safety Instructions Safety Instructions • English Инструкция по технике безопасности • Русский WARNING: This symbol, , when used on the product, is intended to ПРЕДУПРЕЖДЕНИЕ: Данный символ, , если указан alert the user of the presence of uninsulated dangerous voltage within the на...
  • Page 3: Regulatory Compliance

    Regulatory Compliance Guide” on the Extron website. Copyright © 2014 Extron Electronics. All rights reserved. Trademarks All trademarks mentioned in this guide are the properties of their respective owners. The following registered trademarks ®...
  • Page 4: Conventions Used In This Guide

    Conventions Used in this Guide Notifications The following notifications are used in this guide: CAUTION: Risk of minor personal injury. ATTENTION : Risque de blessure mineure. ATTENTION: • Risk of property damage. • Risque de dommages matériels. NOTE: A note draws attention to important information. Specifications Availability Product specifications are available on the Extron website, www.extron.com.
  • Page 5: Table Of Contents

    ....... 15 Receiver Rear Panel ........5 TP Cable Termination........15 Cabling and Setup ..........5 Mounting the USB Extender Plus T/R ....16 Installation Overview ........6 Tabletop Placement ........16 Pairing the Transmitter and Receiver ....7 Rack Mounting ..........16 Connecting for Serial Communication .....
  • Page 6 USB Extender Plus T/R • Contents...
  • Page 7: Introduction

    About the USB Extender Plus T/R The USB Extender Plus T/R extends signals over a single CATx twisted pair cable from USB peripheral devices that are located long distances from the host computer. It is compatible with USB 3.0, 2.0, 1.1, and 1.0 devices with high data transfer rates.
  • Page 8: Application Diagram

    DTP Extension M OT Projector/Display -2 32 U SB -2 32 P OU P LA D IS HDMI IV ER 0- 24 /6 0 Figure 1. USB Extender Plus T/R Application with the Annotator 300 USB Extender Plus T/R • Introduction...
  • Page 9: Installation And Operation

    System Operation • Troubleshooting Connection Guidelines The USB Extender Plus T/R can be installed in existing and new systems within the following guidelines: • USB extenders cannot be cascaded (you cannot sequentially connect a USB Extender Plus T/R to another USB Extender Plus T/R or to a FOX T/R USB Extender Plus).
  • Page 10 480 Mbps (high speed), 12 Mbps (full speed), and 1.5 Mbps (low speed). Output (twisted pair) connector — Connect a TP cable from the RJ-45 Input connector of the receiver (see figure , on the next page) to this female RJ-45 connector. USB Extender Plus T/R • Installation and Operation...
  • Page 11: Receiver Rear Panel

    +12 VDC +12 VDC External External Power Supply Power Supply (12 VDC, 1 A ) (12 VDC, 1 A ) Figure 4. USB Extender Plus T-R Connection with Two External Power Supplies USB Extender Plus T/R • Installation and Operation...
  • Page 12: Installation Overview

    If desired, connect a 9-pin D-to-2.5 mm TRS cable between a computer and the front panel Config port on the transmitter, receiver, or both to configure the units via SIS commands (see Connecting for Serial Communication on page 8). The system is now ready to operate. USB Extender Plus T/R • Installation and Operation...
  • Page 13: Pairing The Transmitter And Receiver

    Pair Link LED turns off and the Link LED on the receiver begins to blink (approximately 10 seconds). Release the button. Pair USB Extender Plus T/R • Installation and Operation...
  • Page 14: Connecting For Serial Communication

    The following peripheral emulation commands can be issued to the transmitter only: • To disable: E E 0 USBC To enable: E • E 1 USBC Remote Configuration and Control, beginning on page 12, for information on entering SIS commands. USB Extender Plus T/R • Installation and Operation...
  • Page 15: Front Panel Features

    While the transmitter is being paired with the receiver, this LED blinks. When the pairing process is completed, the LED lights steadily. USB Extender Plus T/R • Installation and Operation...
  • Page 16: Receiver Front Panel

    If problems are encountered, ensure all cables are routed and connected properly and the latest drivers for each peripheral are installed. USB Extender Plus T/R • Installation and Operation...
  • Page 17: Troubleshooting

    Lights when a connected A peripheral device connected peripheral is recognized by to the USB port has not been the host PC. recognized or is improperly connected. Table 1: System Troubleshooting USB Extender Plus T/R • Installation and Operation...
  • Page 18: Remote Configuration And Control

    Most responses from the USB Extender Plus T/R to the host computer end with a carriage return and a line feed ( = ]), which signals the end of the response character string.
  • Page 19: Error Responses

    Error Responses If the extender is unable to execute a command it receives because the command is invalid or contains invalid parameters, the USB Extender Plus T-R returns an error response to the host. Error response codes and their descriptions are: –...
  • Page 20: Command And Response Table For Sis Commands

    1 = enabled View peripheral X! ] E USBC emulation Resetting NOTE: This command must be issued to both the transmitter and the receiver. Reset Reset the extender to factory default ZXXX values. USB Extender Plus T/R • Remote Configuration and Control...
  • Page 21: Reference Information

    NOTE: Do not use Extron UTP23SF-4 Enhanced Skew-Free™ AV UTP cable to link the transmitter and receiver. Skew-free AV cable is designed for Extron TP transmitter and receiver AV applications. The USB Extender Series does not work properly with this cable. USB Extender Plus T/R • Reference Information...
  • Page 22: Mounting The Usb Extender Plus T/R

    • Through furniture — The transmitter or receiver can be mounted through a desk or other furniture using an optional Extron Through-Desk Mounting Kit for quarter-rack or half-rack width products (see www.extron.com). USB Extender Plus T/R • Reference Information...
  • Page 23 Extron Electronics makes no further warranties either expressed or implied with respect to the product and its quality, performance, merchantability, or fitness for any particular use. In no event will Extron Electronics be liable for direct, indirect, or consequential damages resulting from any defect in this product even if Extron Electronics has been advised of such damage.

This manual is also suitable for:

Usb extender plus r

Table of Contents