Receiver Connections - Extron electronics DTP T DP 4K 330 User Manual

Receiver Connections

DTP Input RJ-45 connector (see
G
of the TP cable from the transmitter output connector to this RJ-45 female
connector. Ensure the opposite end of this cable is connected to the
transmitter DTP Output RJ-45 connector (see
ATTENTION:
•
•
NOTE: See
wire the RJ-45 connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a valid signal on the DTP In connector.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
DisplayPort output connector — Connect a video display to this
H
DisplayPort connector.
Audio output connector — This 5-pole, 3.5 mm captive screw connector outputs
I
the transmitted, unamplified, line level analog audio. Connect an audio device, such as
an audio amplifier or powered speakers.
See figure 5 to properly wire a captive screw output connector. Use the supplied
tie-wrap to strap the audio cable to the extended tail of the connector.
Do not tin the wires!
Figure 5.
ATTENTION:
•
•
NOTES:
•
•
Over TP RS-232 and IR connector — Connect a serial RS-232 signal,
J
a modulated IR signal, or both to this 3.5 mm, 5-pole captive screw
connector for bidirectional RS-232 and IR communication
(see RS-232 and IR connector wiring
DTP T/R DP 4K 330 and DTP T/R DP 4K 230 Twisted Pair Extenders • Installation and Operation
Do not connect these devices to a telecommunications or computer data
network.
Ne connectez pas ces appareils à des données informatiques ou à un réseau
de télécommunications.
TP cable termination and recommendations
NO GROUND HERE
Tip
Sleeves
Tip
NO GROUND HERE
Unbalanced Stereo Output
Captive Screw Connector Wiring for Stereo Audio Output
For unbalanced audio, connect the sleeves to the ground contact.
DO NOT connect the sleeves to the negative (-) contacts.
Pour l'audio asymétrique, connectez les manchons au contact au sol.
Ne PAS connecter les manchons aux contacts négatifs (–).
The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
• If the stripped section of wire is longer than 3/16 inch, the exposed wires
may touch, causing a short circuit.
• If the stripped section of wire is shorter than 3/16 inch, wires can be easily
pulled out even if tightly fastened by the captive screws.
Do not tin the power supply leads before installing them in the connector.
Tinned wires are not as secure in the connector and could be pulled out.
figure 3 on page 3) — Connect one end
item , on the previous page).
E
Tip
Ring
Tip
Ring
Balanced Stereo Output
on page 10 to wire the connector).
SIG LINK
DTP IN
on page 7 to properly
DISPLAYPORT
OVER TP
RS-232 IR
Tx Rx G Tx Rx
6