Receiver Connections, Controls, And Indicators; Rear Panel - Extron electronics FOXBOX Tx HDMI User Manual

Receiver Connections, Controls, and Indicators

Rear panel

19
POWER
12V
1.0A MAX
Figure 4.
l
HDMI Output connector — Connect a video display to this HDMI connector. See
"HDMI
m
HDMI Audio switch — This switch mutes (Off position) and unmutes (On position) the
embedded audio output on the HDMI output connector. The audio on the captive screw
output always remains active regardless of the setting of this switch.
n
Audio output connector — This 5-pole, 3.5 mm captive
screw connector outputs the transmitted, unamplified, line level audio.
Connect audio devices, such as an audio amplifier or powered speakers. See
"Audio output
for the appropriate output type and impedance level.
o
RS-232 Over Fiber port — If you want the FOXBOX to pass serial
command signals to a slave device, for serial control of a projector for
example, connect the slave device to the receiver via the first three leftmost
poles (Tx, Rx, and
connections" on page 13 to wire this connector.
NOTES:
p
Alarm outputs port — For remote monitoring of the status of fiber optic
link 1, connect a locally-constructed or furnished monitoring device to the
receiver via the two rightmost poles (1 and 2) of this 5-pole captive screw
connector. When the receiver does not detect a light link on fiber cable Rx,
pin 1 and pin 2 of this port are shorted together (see
page 13 to wire this connector).
17
Tx Rx
HDMI AUDIO
FOXBOX Rx HDMI
OPTICAL
FOXBOX Rx Receiver Rear Panel Features
connector" on page 12 for pin assignments.
connector" on page 14 to wire a captive screw connector
_
) of this 5-pole captive screw connector. See
• If you connect only one fiber optic cable
you configure the receiver for daisy-chaining, you will not receive reports
from the controlled device. To receive responses from the controlled
device, you must install two fiber optic cables and leave link 2 enabled
SIS command
(via an
Control Program).
• The FOXBOX can pass RS-232 commands and responses at rates up to
115200 baud.
FOXBOX Tx/Rx HDMI • Installation and Operation
13 12 14
OUTPUTS
AUDIO
L R
ON
HDMI
OFF
(item q , on the next page), or
to the receiver or using the
"Alarm outputs
15 16 18
RS-232 REMOTE
OVER FIBER ALARM RS-232
Tx Rx 1 2 Tx Rx
AUDIO
L R
RS-232
OVER FIBER ALARM
Tx Rx 1 2
"RS-232
FOX Extenders
RS-232
ALARM
OVER FIBER
Tx Rx 1 2
connection" on
9