Front And Side Panel Features And Connections; Transmitter Connections - Extron electronics eLink 100 User Manual

Front and Side Panel Features and Connections

Transmitter Connections

Figure 2.
A
B
C
A
POWER
SERVICE
5V
1.5A MAX
Front Panel
eLink 100 T Transmitter Side Panels
Power input connector — Plug the external 5 VDC power supply into this 5 V jack
to power the transmitter.
NOTES:
•
Use only the power supply provided by Extron. See the
for important information.
• The USB mini-B port to the right of this connector is reserved for use by Extron
service personnel.
• See Installing the Plug on the Power Supply
supply plug is needed for your location.
HDMI In connector — Connect an HDMI cable between this port and the HDMI
output port of the digital video source device.
IR Out connector — (Optional) Connect the tip-ring-sleeve end of the provided IR
emitter to this IR Out connector. Use the included double-sided adhesive tape to attach
the head of the IR emitter directly over the IR receiver window of the source device.
IR remote signals are passed from the receiver to the IR Out connector on the
transmitter. This feature allows the user to point the remote control toward the receiver
(by the display) instead of the source device, should the source device be in a different
location.
B
HDMI IN
Side Panel
eLink 100 HDMI Transmitter and Receiver • Installation
C
IR OUT
Attention
on page 7
on page 7 if a different power
5