Using The Remote Control And The Osd Menus; Remote Control Buttons - Extron electronics eLink 100 User Manual

Using the Remote Control and the OSD Menus

Remote Control Buttons

Use the eLink 100 IR remote to control and navigate the OSD.
NOTE: The remote control must be pointed at the IR sensor on the front panel of the
CAUTION:
Figure 8.
A
B
C
receiver (see figure 3, , on page 6) from a distance of no more than 30 feet
A
(9.1 meters) and no more than 40º from center.
• Risk of explosion. Do not replace the battery with an incorrect type. Dispose of
used batteries according to the instructions.
• Risque d'explosion. Ne pas remplacer la pile par le mauvais type de pile.
Débarrassez-vous des piles usagées selon le mode d'emploi.
EXIT SOURCE
MENU
OK
ADD
DELETE GUEST
+
INPUT DEVICES
2 3
1
eLink 100 IR Remote Control
Menu — Displays the OSD
page).
Exit — Returns to the previous menu. If the
button closes the OSD.
Source — Displays the
Select Video Source
registered to the receiver.
NOTE: The eLink 100 does not support applications with multiple transmitters to
one receiver. Only one transmitter should be used with as many as four receivers.
Select Video Source
EXTRON112
Setup
Figure 9. Select Video Source
A A
B B
A
B
C C
C
D D
D
E E
E
F
G
F F
H
G G
I
H H
I I
menu (see Using the Setup Menu
Setup
menu is displayed, pressing this
Setup
menu, which lists the transmitter that is
eLink 100 HDMI Transmitter and Receiver • Operation
Menu
Exit
Source
Direction arrows
OK
Delete
Add
Guest (Not Used)
Input Devices buttons
(Not Used)
on the next
12