The Elink 100 On-Screen Display; Top Panel Features And Functions; Transmitter Buttons And Leds - Extron electronics eLink 100 User Manual

To remove a power plug from the power supply, press downward on the latch (marked
with an arrow) below the plug recess.

The eLink 100 On-screen Display

When the receiver is powered and connected to the display device, the On-screen Display
(OSD) appears. See the

Top Panel Features and Functions

The eLink 100 controls and indicators are located on the top panels of the transmitter and
receiver.

Transmitter Buttons and LEDs

Figure 6.
A
B
C
D
E
Operation
Extron
eLINK 100 T
LINK
VIDEO
POWER
REGISTER
RESET
eLink 100 T Transmitter Top Panel
Link LED — Blinks while the receiver is searching for a link to register with the
Registering the Transmitter with the Receiver
transmitter (see
link has been made, this LED lights steadily.
Video LED — If the transmitter is registered with the receiver, this LED lights steadily
when a valid source video format is detected and transmitted (see
Rates table on page 18).
Power LED — Lights steadily while power is connected to the transmitter.
Register button — Hold this button after starting the registration process on the
receiver (see Registering the Transmitter with the Receiver
Reset button — Press this button to reset the transmitter, if needed for troubleshooting
(see Troubleshooting on page 20).
section on page 10 for instructions on using the OSD.
A A
B B
C C
D D
E E
eLink 100 HDMI Transmitter and Receiver • Installation
on page 10). When a
Resolutions and
on page 10).
8