Reference Information; Mounting The Transmitter And Receiver - Extron electronics eLink 100 User Manual

Reference
Information
This section includes the following reference information:
•
•
•
•

Mounting the Transmitter and Receiver

ATTENTION:
NOTE: Before mounting, see
The eLink 100 units can be placed on a table or mounted to a wall. For the transmitter and
receiver to communicate, they must be no further than 100 feet (30 meters) apart with a
clear line of sight.
To mount the transmitter or receiver to a wall or furniture:
1.
2.
3.
Mounting the Transmitter and Receiver
Resolutions and Rates
Operating Frequencies
Troubleshooting
• Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé
uniquement.
page 17.
Print and cut out the template for the unit to be mounted (cutout templates are available
at www.extron.com).
Tape the template to the wall in the desired location.
Drill pilot holes through each of the mounting hole centers on the template and into the
wall or furniture (see figure 12).
2.44 inches
(6.20 cm)
Transmitter Template
Figure 12. Drill through the Center of the Two Mounting Hole Circles on the
Transmitter or Receiver Template
eLink 100 HDMI Transmitter and Receiver • Reference Information
Best Practices for eLink 100 Mounting Locations
Drill
Mounting
Holes
on
Drill Mounting Holes
1.87 inch
(4.75 cm)
Receiver Template
15