Table of Contents
Advertisement
Receiver Connections
The DTP DVI 4K 230 D receiver is in an enclosure that can be mounted in UL-listed
standard wall boxes with decorator-style face plates.
Receiver Rear Panel
Figure 7 shows the rear panel of the DTP DVI 4K 230 D receiver.
A
Figure 7.
A
Connect the opposite end of the twisted pair cable to the receiver input port shown in
figure 7 (see
TP Cable Termination and Recommendations
wire the RJ-45 connectors).
NOTES:
•
In order to fit in the junction box, the twisted pair cables and RJ-45 connectors
should not have a boot installed.
•
Do not use Extron STP201 or Skew-Free UTP series cable with these
products
SIG
LINK
DO NOT
CONNECT
TO LAN
DTP IN
DTP DVI 4K 230 D Rx
DTP DVI 4K 230 D Receiver Rear Panel Connectors
Receiver input port — Connect one end of a twisted pair cable to this RJ-45 input
port.
ATTENTION:
•
Do not connect this device to a telecommunications or computer data
network.
•
Ne connectez pas cet appareil à un réseau de télécommunications ou de
données informatiques.
Connect the opposite end to the RJ-45 output (see figure 7 above) on the transmitter
(see
TP Cable Termination and Recommendations
RJ-45 connectors).
DTP DVI 4K 230 D Transmitter and Receiver • Installation and Operation
+ -
B
POWER
12V
0.8 A MAX
on page 10 to properly wire the
on page 10 to properly
8
Advertisement
Table of Contents
