Table of Contents
Advertisement
TP Output RJ-45 connector — Connect one end of a TP cable to this
E
RJ-45 female connector on the transmitter. Ensure the opposite end of this
cable is connected to the receiver TP Input RJ-45 connector (see item
below).
ATTENTION:
•
•
NOTE: See
wire the RJ-45 connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a DisplayPort signal on the DisplayPort
input.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
Power connector — Plug the included external 12 VDC power supply into either this
F
2-pole connector or the power input connector on the receiver (see
ATTENTION:
•
•
NOTE: When the TP function switch (see
position, one power supply can power both units.
and receiver each requires a local 12 VDC power supply.
Receiver Connections
DTP Input RJ-45 connector — Connect one end of the TP cable from
G
the transmitter output connector to this RJ-45 female connector. Ensure the
opposite end of this cable is connected to the transmitter DTP Output RJ-45
connector (see item
ATTENTION:
•
•
NOTE: See
wire the RJ-45 connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a valid signal on the DTP In connector.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
DTP DP 330 and DTP DP 230 Twisted Pair Extenders • Installation and Operation
Do not connect these devices to a telecommunications or computer data
network.
Ne connectez pas ces appareils à des données informatiques ou à un réseau
de télécommunications.
TP cable termination and recommendations
Do not connect power to the DTP DP 330 or DTP DP 230 until you have read
the
CAUTION
and
ATTENTION
Ne branchez pas l'alimentation au DTP DP 330 ou DTP DP 230 avant d'avoir lu
les deux rubriques «
ATTENTION
When the TP function switch is in the HDBT position, the transmitter
, above).
E
Do not connect these devices to a telecommunications or computer data
network.
Ne connectez pas ces appareils à des données informatiques ou à un réseau
de télécommunications.
TP cable termination and recommendations
on page 7 to properly
notices on pages 8 and 9.
» aux pages 8 et 9.
item
on page 4) is in the DTP
D
on page 7 to properly
SIG
LINK
,
G
OUT
item
on page 6).
K
SIG
LINK
DTP IN
5
Advertisement
Table of Contents
