3.
Press and hold the Register button on the transmitter top panel until the following
message appears on the OSD:
Exit to cancel
4.
Press the OK button on the remote control (see
The message
while the registration process is completing.
NOTE: Registration may take up to 60 seconds to complete. If the process is
delayed more than 60 seconds, cycle power on both units, then restart the
registration process.
When registration is complete, the message and progress bar disappear from the
display. The Link LED and the Video LED light steadily.
Registering Using the Register Buttons
To register the transmitter with a receiver without using the remote control:
1.
Connect and apply power to the transmitter, input source, receiver, and output source.
NOTE: The registration process can be done without an input connected. In this
case, a message appears on the OSD, notifying you of a missing video source.
2.
Press and hold the Register button on the receiver top panel until the following
message appears on the OSD:
.
Unit
3.
Press and hold the Register button on the transmitter top panel until the following
message appears on the OSD:
Adding transmitter name
4.
Press the Register button on the receiver to confirm. The message
transmitter name...
process is completing.
NOTE: Registration may take up to 60 seconds to complete. If the process is
delayed more than 60 seconds, cycle power on both units, then restart the
registration process.
When registration is complete, the message and progress bar disappear from the
display. The Link LED and the Video LED light steadily.
Registering an Additional Receiver
To register an additional receiver with a transmitter:
1.
Power down all receivers except the one you are registering.
2.
Perform steps 2 through 4 above for your preferred method of registering the receiver
(using the remote control or using the register buttons).
3.
When registration is complete, power on the other receivers. The video should be
displayed on all monitors.
Adding transmitter name
Adding transmitter name...
Please Activate Registration on Transmitter
.
Press OK to continue or Exit to cancel
and a progress bar appear on the OSD while the registration
eLink 100 HDMI Transmitter and Receiver • Operation
.
Press OK to continue or
figure
8,
, on page 12) to confirm.
E
and a progress bar appear on the OSD
Adding
11