Print Mode; Paper Select Mode; Pdf Settings - Fuji Xerox DocuPrint CM405 df User Manual

• Paper Select Mode

Purpose:
To set the way to select the paper tray for PostScript mode.The change becomes effective after the printer is turned
off and then on again.
Values:
Auto*
Select From Tray
• Output Color
Purpose:
To specify the color mode to Color or Black and White. This setting is used for a print job which does not specify a

print mode.

Values:
Color*
Black and White

PDF Settings

Use the PDF Settings menu to change printer settings that only affect the PDF jobs.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Quantity
Purpose:
To specify the number of copies to print.
Values:
*
1
1–999
• 2 Sided Print
Purpose:
To specify whether to print on both sides of a sheet of paper.
Values:
1 Sided*
2 Sided Binding Edge
• Print Mode
Purpose:
To specify the print mode.
Values:
*
Normal
High Quality
High Speed
298
Using the Operator Panel Menus and Keypad
The tray is selected as the same setting as in the PCL mode.
The tray is selected in a method compatible with regular PostScript printers.
Prints in color mode.
Prints in black and white mode.
Sets the value in increments of 1.
Does not print on both sides of a sheet of paper.
*
Long Edge Flip Prints on both sides of a sheet of paper to be bound by long edge.
Short Edge Flip Prints on both sides of a sheet of paper to be bound by short edge.
For documents with normal sized characters.
For documents with small characters or thin lines, or documents printed using a dot-matrix
printer.
Prints with the higher speed than the Normal mode, but the quality is less.