Voice Vlan Properties - NETGEAR GS748T Software Administration Manual

Voice VLAN Properties

To display the Voice VLAN Properties page, click Switching
Properties.
To configure Voice VLAN:
From the Voice VLAN Status field, enable or disable Voice VLAN on the switch. If the
1.
switch does not handle traffic from IP phones, the status should be disabled.
From the Voice VLAN ID field, select the VLAN to use for voice traffic on the switch. The
2.
VLAN must already exist on the switch. For information about how to create VLANs, see
VLAN Configuration
3. From the Class of Service field, set the CoS tag value to be reassigned for packets
received on the Voice VLAN when Remark CoS is enabled.
4. From the Remark CoS field, select Enable or Disable to reassign the CoS tag value to
packets received on the Voice VLAN.
5. From the Voice VLAN Aging Time field, specify the amount of time after the last IP phone's
OUI is aged out for a specific port. The port will age out after the bridge and voice aging
time.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. If you make any changes to this page, click Apply to send the updated configuration to the
switch.
GS748T Smart Switch
on page 86.
91
Voice VLAN Basic
  